Custom Configuration For A University Laboratory
This custom XVC unit was built so that the customer, a university laboratory complex, could provide their own exhaust air blower section. Unlike most XVC units, which have exhaust air inlets on the bottom and exhaust air outlet sections on top, exhaust air enters this unit through one of its sides and passes straight out the other. In this airstream, XeteX only provided the exchanger and dampers. On the supply side, however, XeteX built the unit with cold water and steam coils, final filters, dampers, actuators, an air foil plenum blower, and a humidifier section. When finished, this unit gave the lab operators complete control over temperature and humidity, year-round energy recovery, and a custom configuration that met their requirements.
- Model: XVC–60–60–RT–BP–HS–CW–SP
- Supply cfm: 10,500
- Exhaust cfm: 10,500
- Built: March, 2006
- Weight: 9,000 lbs
- Energy Recovered: 741 MBH (Winter) 117 MBH (Summer)
- Design Conditions: –20 °F / 99% RH (Winter) 90 °F / 45% RH (Summer)
- An XLT Type H Aluminum Flat Plate Exchanger operates at 62% effectiveness under summer conditions and 69% under winter.
- The Double Wall cabinet has an 18 gauge Epoxy-Coated Galvannealed Steel Exterior, 20 gauge Galvanized Interior, and 2” thick Fiberglass Insulation. Frame is Welded Structural Steel.
- The 36” quiet Air Foil Plenum supply air blower is belt driven by a Premium Efficient 15 hp motor. The exhaust air blower section was provided by others.
- A Cold Water coil provides 687 MBH cooling and a Steam Coil provides 1196 MBH heat. The humidifier section provides 275 lbs/hr of moisture.
The XeteX unit featured on this page was built for an actual application. It is provided here to show our capability.